Register once, drag and drop ECAD models into your CAD tool and speed up your design.

Click here for more information


20-bit registered driver with inverted register enable and 30 Ω termination resistors (3-state)

The 74ALVC162836A is an 20-bit universal bus driver. Data flow is controlled by output enable (OE), latch enable (LE) and clock inputs (CP).

When LE is HIGH, the A to Y data flow is transparent. When LE is HIGH and CP is held at LOW or HIGH, the data is latched; on the LOW to HIGH transient of CP the A-data is stored in the latch/flip-flop.

The 74ALVC162836A is designed with 30 Ω series resistors in both HIGH or LOW output stages.

When OE is LOW the outputs are active. When OE is HIGH, the outputs go to the high impedance OFF-state. Operation of the OE input does not affect the state of the latch/flip-flop.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

Orderable parts

Type number Orderable part number Ordering code (12NC) Package Buy from distributors

Features and benefits

  • Wide supply voltage range of 1.2 V to 3.6 V
  • Complies with JEDEC standard no. 8-1A
  • CMOS low power consumption
  • Direct interface with TTL levels
  • Current drive ±12 mA at 3.0 V
  • MULTIBYTETM flow-through standard pin-out architecture
  • Low inductance multiple VCC and GND pins for minimum noise and ground bounce
  • Output drive capability 50 Ω transmission lines @ 85 °C
  • Integrated 30 Ω termination resistors
  • Diode clamps to VCC and GND on all inputs
  • Input diodes to accommodate strong drivers



Type numberProduct statusPackage name
74ALVC162836ADGGEnd of lifeTSSOP56

Documentation (3)

File nameTitleTypeDate
74ALVC162836A20-bit registered driver with inverted register enable and 30 Ohm termination resistors; 3-stateData sheet2018-04-06
alv2836aalv2836a IBIS modelIBIS model2013-04-07
SSOP-TSSOP-VSO-WAVEFootprint for wave solderingWave soldering2009-10-08


If you are in need of design/technical support, let us know and fill in the answer form, we'll get back to you shortly.


File nameTitleTypeDate
alv2836aalv2836a IBIS modelIBIS model2013-04-07